Milltronics PL-551 Informacje Techniczne Pobierz pdf (Strona 161)

100

101

SECTION THREE - CONVERSATIONAL INPUT SCREENS

F5 (Polyg) Mill-Pockt-Polyg

The conversational screen for the polygon cycle appears below.

Note: see page 231 , Section 4 for further information on the polygon cycle.

F6 (Frame) Mill-Frame

The F6 (Frame) frame mill selection brings up the following soft keys.

F1 (Setup) Mill-Frame-Setup

The F1 (Setup) screen is used to set parameters necessary for circular and rectangular frame mill

routines. Setting parameters must be done prior to any frame milling routines.

Mill START and END are not to be used with frame routines.

Note: All milling autoroutines must be activated with the tool at the center of the routine.

The framing autoroutines can use the G65 X___Y___ to specify the center.

The conversational screen for frame mill setup appears as follows.

147

1 2 ... 156 157 158 159 160 161 162 163 164 165 166 ... 440 441

Komentarze do niniejszej Instrukcji

Brak uwag

Milltronics PL-551 Informacje Techniczne Strona 161

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Nie Milltronics PL-551