Milltronics PL-551 Informacje Techniczne Pobierz pdf (Strona 55)

100

101

SECTION TWO - FRONT PANEL OPERATION

Put Pot down on Yes means the pot will be down for the pending tool.

swing arm tool changers: No means it will be up.

Check drawbar switch: Yes for newer machines with drawbar switches.

Milltronics ATC is: Plunger, Geneva Two-Step, Geneva One-Step or Swing Arm

Milltronics CW Coast: Partner 1 Geneva tool changers use these

Milltronics CW Brake: Parameters to set the times to index and

Milltronics CCW Coast: brake the tool changer in the CW and CCW

Milltronics CCW Brake: directions. Suggested values are 110 for coast and 60 for brake.

Check Air Pressure: If the parameter is set to yes and the pressure is low (Y input #1),

the machine will emergency stop and error 448 “Air Pressure

Error. Check air hose connection” will occur.

Drawbar Delay: Used in the Partner tool changers as a delay (in seconds) after the

drawbar comes on and before the head goes up to remove the tool

to prevent pulling on the tool holder.

Custom M and G code Tables

Custom G code O9010

Custom G code O9011

Custom G code O9012

Custom G code O9013

Custom G code O9014

Custom G code O9015

Custom G code O9016 Cannot have a custom G code for G0

Custom G code O9017

Custom G code O9018

Custom G code O9019

Custom M code O9020

Custom M code O9021

Custom M code O9022

Custom M code O9023

Custom M code O9024

Custom M code O9025

Custom M code O9026 Cannot have a custom M code for M0

Custom M code O9027

Custom M code O9028

Custom M code O9029

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 440 441

Komentarze do niniejszej Instrukcji

Brak uwag

Milltronics PL-551 Informacje Techniczne Strona 55

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Nie Milltronics PL-551