Milltronics CVCC Instrukcja Obsługi Pobierz pdf (Strona 13)

INSTALLATION

BIC-II

The BIC-II should be mounted in an area that will allow operation within the specified operating temperature

range and that is suitable for NEMA 4 enclosures and polycarbonate material. The front cover should be

accessible and have sufficient room to swing open.

Refer to Fig. 1 - Outline and Mounting Detail.

It is advisable to keep the BIC-II away from high voltage or current runs, SCR control drives and RF

interference.

Do not mount the BIC-II in direct sunlight without the use of a sun shield.

INTERCONNECTION

Communication cables may be run in a common grounded metal conduit separate from power wiring.

Connect the data output of the product(s) to the BIC-II communication port(s), starting with PORT1. Refer to

FIG. 3.

For multiple BIC-II applications, interconnect the BIC-II MillBus terminals. The MillBus cable shield should be

connected to a BIC-II at one end only, preferably the end where the MillBus Out connection is made. Refer to

FIG. 3G - MillBus / Multiple BIC-II Interconnection.

Connect the BIC-II to the host computer or PLC serial port. Refer to Appendices/PLC Requirements. Refer to

the computer or PLC manufacturers instruction manual to determine appropriate RS-232 or RS-422

connection requirements. Refer to FIG. 3H - Host Interconnection.

Connect the power wiring to the BIC-II(s). Refer to FIG. 3I - Power Wiring Detail.

All wiring must be done in conjunction with

approved conduit, boxes and fittings, and to procedures

in accordance with all governing regulations.

INTERNAL CHECKS

Ensure the BIC-II (board B) voltage selection jumper (J2) and MillBus common selection jumper (J1) are in

the appropriate position. Refer to FIG. 3I - Power Wiring Detail.

Ensure the 100 Ω termination resistor is installed on the proper unused BIC-II MillBus terminals. Refer to FIG.

3G - MillBus / Multiple BIC-II Interconnection.

Ensure jumper(s) are properly connected to the unused RS-232 or RS- 422 BIC-II terminals. Refer to FIG. 3H

BIC-II - Host Interconnection.

Do not operate the BIC-II with the ground (earth) wire disconnected.

■

PL-371 3 – 1

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 75 76

Brak uwag

Milltronics CVCC Instrukcja Obsługi Strona 13